OPERATING INSTRUCTIONS
READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL
BEFORE OPERATING SPOTLIGHT.
Step 1:
To activate spotlight, plug the cigarette lighter adapter into a
cigarette lighter receptacle. Move switch to ON.
WARNING:
Never place spotlight face down when light is on or is
still hot from recent use. Doing so could burn/ignite
surfaces such as seats, carpeting, etc. and cause major
property damage. Always turn spotlight off and unplug
from power source when not in use.
Step 2:
To deactivate, move switch to OFF and unplug from power
source.
To Replace Bulb
Lens
Rear
Housing
Front
Housing
Reflector
Only use a Brinkmann halogen bulb that is designed for the Q-Beam Max
Million
III
spotlight as a replacement. Use of any other bulb may result in
poor performance and may damage your spotlight.
IMPORTANT:
Do not touch the glass part of bulb with fingers as natural
oils affect the life and performance of bulb. Handle bulb by
metal end only.
Step 1:
Disconnect spotlight from power source.
Step 2:
Remove the two screws from top and bottom of front housing
(see Figure 1).
Step 3:
Lay the spotlight face (lens) down on a flat surface.
Step 4:
Holding the front housing secure, slowly lift the rear housing off
being careful not to pull wire connections inside. Make sure the
reflector is inside the front housing as shown in Figure 2. Do
not touch the inside of reflector.
NOTE:
The glass lens is not attached to front housing. Use care when
disassembling to avoid breaking lens.
2
FIGURE 1
800-2301-0_INSTR-MAXMILL3 9/4/03 10:07 AM Page 4
