8
Note:
After installing the main
housing and solar panel
module, leave the switch in
the “OFF” position and
charge in
FULL, DIRECT
SUNLIGHT
for THREE FULL
DAYS. Then remove the
switch label and slide the
switch to the “AUTO”
position. The light will turn
on automatically at night
when it detects motion.
Troubleshooting &
Important Information
(continued)
IMPORTANT: The sealed battery in
this product contains
lead and must be
recycled or disposed
of properly. For
additional
information
regarding disposal,
contact your local
county solid waste
authority.
b. If the weather has been cloudy or overcast during the day, the
battery will not be charged for operation at night. The light must
have direct sunlight every day to fully charge the battery. If the light
does not receive enough sunlight one day, it will recharge the next
sunny day and resume normal operation.
c. Check the battery on a voltage meter to ensure that battery is
charged to a full voltage of 6-volts. An electronics store will usually
check batteries at no charge. Battery should be replaced
periodically throughout the year, especially after winter months.
d. Diminishing light or gradual decrease in number of activations
indicate a dying battery that requires replacement. Replacement
battery may be purchased from The Brinkmann Corporation
Customer Service Department by calling 800-468-5252.
•
Loose or burned out bulb. Bulbs can become loose over time. Check
and tighten the bulb periodically. If the bulb has burned out, a
replacement can be easily installed. Replacement bulbs may be
purchased from The Brinkmann Corporation Customer Service
Department by calling 800-468-5252.
•
Dirty Solar Panel. A dirty solar panel will not allow the battery to fully
charge. This will shorten battery life. Clean regularly with a dampened
cloth or paper towel.
If lights come on randomly:
•
Aim motion detector head lower.
•
Cover areas which may be reflecting signals to motion sensor such as:
cooling or heating ducts, reflective surfaces, metal sheds, smooth walls
or windows, etc..
•
Rotate the detector head right or left a few degrees.
•
Mount your motion detector on a firm surface as vibrations can false
trigger the unit.
•
Aim detector away from busy streets or sidewalks, trees and bushes.
If range is too short or too long:
•
Position your motion detector so movement is across detection zone.
•
Aim detector upward to increase range or downward to decrease range.
CAUTION: Do not use any other battery size or type. It will damage the
unit and void the warranty. Do not attempt to open the
detector housing. There are no user serviceable parts inside.
INSTR_821-7000-0_SL7.qxd 5/17/06 4:29 PM Page 9
