BRINKMANN PUMPS Bplogic, Руководство по эксплуатации, Страница: 140 / 291

5 Operating the pump controller
140 bplogic intelligent pump controller 18/02/2021

C
o
n
fi
g
_
L
o
g
ic
-mo
d
u
le
_
G
e
n
e
ra
l0
2
.p
n
g
Fig. 79
: “General”
3. Enter the required number of action blocks (Fig. 79/1).
4. If several action blocks are defined, specify the sequence in which the action
blocks should run. To do so, type the numbers for the action blocks that the ap-
plication module should run into the input fields in the required sequence
(Fig.
79/2).
 The action block number that you enter into the “Action block 1” input field
will run first.
 The action block number that you enter into the “Action block 6” input field
will run last.
5. Restarting the pump controller:

Section 5.6.2.7
“
Device restart
”
on page 200.
Adding actions to an action block or deleting actions from an action block
Actions of action blocks action run according to their number sequence. This means
that in an action block that contains actions 21 - 40, action 21 runs first and action
40 runs last.
As soon as an action for which no command parameters have been set runs, no
further actions are executed. This means that if parameters are set for actions 1
–
10 in an action block and no command parameters are set for action 11, only
actions 1
– 10 run.