7
Duct Cover Installation
6. Use 6” round steel pipe for 30” and 36” models
or 8” round steel pipe for 48” models (follow
building codes in your area) to connect the
exhaust on the hood to the ductwork above.
Use duct tape to make all joints secure and air
tight. Refer Figure 5.
7. Use four 4mm x 8mm screws (included) to attach
duct cover to hood. Refer to Figure 6.
Install Accessories
8. Attach oil tunnel. Refer to Figure 7.
9. Refer to Figure 8.
Slide the baffle filter into
the hood.
Push the baffle filter upward.
Slide forward.
Pull downward.
Fit into
place.
10. Repeat until all baffle filters and spacers are
resting against oil tunnel. Refer to Figure 8.
Final Assembly
11. Turn power ON in control panel. Check all lights
and fan operation.
12. Make sure to leave this manual for the
homeowner.
Figure 7
Figure 8
