Brill Hattrick 40 BHR, Руководство пользователя

Страница: 24 / 100

GB
24
A
Check each time you use
the equipment
Inspect the equipment each time
before you use it. Do not use
the equipment if safety devices
(switch handle, safety covers)
and / or if the cutting device is
damaged or worn.
Never disable safety devices.
Always carry out a visual
inspection before use in order
to determine whether the cut-
ting tool is worn or damaged
and that no screws are loose.
Check the work area before
starting work. Remove any for-
eign bodies present (e. g. stones,
branches or bones). Check for
foreign bodies whilst working.
Always wear sturdy footwear
and long trousers when working
with the appliance. Do not use
it when barefooted or only
wearing light sandals.
Warning! petrol is extremely
inflammable.
Only keep petrol in the container
provided for the purpose.
Always fill the tank outdoors
and do not smoke when filling
the tank with petrol.
Fill up with petrol before starting
the engine.
Stop the engine before topping
up.
Never open the tank cap or top
up with petrol whilst the engine
is running or the equipment is
hot.
For safety reasons, do not attempt
to start the engine if the petrol
has overflowed. Instead, remove
the equipment from the area
contaminated with petrol. Doe not
make any attempt whatsoever to
start the engine until all the
petrol vapours have evaporated.
For safety reasons, the petrol
tank and tank cap must be
replaced if damaged.
Always replace damaged
exhaust components.
Check the cutting tools regularly
for damage and have them
repaired correctly if necessary.
Only have cutting tools replaced
by Brill Service or your
authorised specialist dealer.
A
Use /
Responsibility
A
Warning! The safety
devices installed on the
appliance by the manufacturer
are neither to be removed nor
bypassed as this can result in
injury.
Make sure that there are no
other people (especially children)
or animals within or near the
working area.
11. Instructions for correct use, safety instructions
Fault Possible Cause Remedy
Readjust the clutch cable. Clutch cable stretched.
Drive belt is to be replaced.
Obtain assistance from
a Brill Service Station. Drive belt broken.
Wheel drive not functioning.
Allow lawn to dry,
do not mow if grass is wet. Ground softened by water,
lawn too wet. Mower leaves deep tracks.
Change blade and / or use
a slightly higher cutting height. Blade is too blunt,
cutting height too low. Lawn turning yellow,
cut not clean.
V-belt must be replaced by
specialist workshop. V-belt torn.
Turn rotary switch to 1 with the
motor switched off. Rotary switch at 0 position.
Aerator roller is not operating
with the blade.
Motor overhaul at specialist
workshop required. Cylinders, pistons and bearing
of crankshaft have seized.
No motor oil in crankcase.
Motor starts for a short time
then suddenly stops with a loud
bang.
Clean spark plug and / or
fill the fuel tank. Spark plug defective or
fuel tank empty. Motor does not start.