9. Repeat steps 2 through 5 to secure the third and fourth
wheels.
10. Attach handles (
H
) to brackets on generator frame as
shown, with 45 mm capscrews (
J
), flat washers (
K
),
nylon washers (
L
), and M8 lock nuts (
M
).
NOTE:
DO NOT overtighten. Handles must be able to move
up and down freely.
11. Return generator to normal operating position (resting
on wheels).
12. To apply brakes, push down firmly on handle of both
clamps until it locks in the down position and engages
the wheels.
IMPORTANT:
The generator is designed to be used on level
surfaces.
13. Loop handle pins (
N
) on generator frame just above
handle brackets.
14. Raise handles and insert handle pins to move
generator.
15. To release brakes, pull up on handle of both clamps
until it locks in the up position.
Add Engine Oil
• Place generator on a level surface.
NOTE:
Verify provided oil bottles are the correct viscosity for
current ambient temperature.
• Refer to engine operator’s manual and follow oil
recommendations and instructions.
NOTE:
Check oil often during engine break–in. Refer to
engine operator’s manual for recommendations.
Add Fuel
NOTE:
Refer to engine operator’s manual and follow fuel
recommendations.
1. Clean area around fuel fill cap, remove cap.
2. Slowly add unleaded gasoline (
A
) to fuel tank (
B
). Be
careful not to fill above the baffle (
C
). This allows
adequate space for fuel expansion as shown.
3. Install fuel cap and let any spilled fuel evaporate before
starting engine.
NOTICE
Any attempt to crank or start the engine before it has been
properly filled with the recommended oil will result in
equipment failure.
• Refer to engine manual for oil information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
FUEL
TANK
C
B
A
8
BRIGGSandSTRATTON.COM
WARNING
Fuel and its vapors are extremely flammable and
explosive.
Fire or explosion can cause severe burns or
death.
WHEN ADDING FUEL
• Turn generator OFF and let it cool at least 2 minutes before
removing fuel cap. Loosen cap slowly to relieve pressure in
tank.
• Fill fuel tank outdoors.
• DO NOT overfill tank. Allow space for fuel expansion.
• If fuel spills, wait until it evaporates before starting engine.
• Keep fuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
• DO NOT light a cigarette or smoke.
