8
9
English
Installing the product
Select an installation
location that can record the
entire view in front of the
vehicle without obstructive
the driver’s vision. Ensure
that the front camera lens is
located in the center of the
windshield.
1. Refer to the fi gures below to install the camera to the windshield.
1
2
3
4
2. Remove the product from the mount, and then push the mount against
the windshield to fi x it fi rmly.
3. Reattach the product to the mount, and then adjust the camera angle.
• To confi rm the camera angle, record a video after installation and check the
video using the PC viewer. If necessary, adjust the camera angle again.
• Tighten the fi x screw using a fl at-head screwdriver or a coin.
• The product may fall and be damaged during vehicle operation if it is not
fi rmly fi xed to the mount.
• If you need to remove the mount from the windshield to alter the installation
location, be careful not to damage the windshield’s fi lm coat.
Connecting and arranging the power cable
When the engine and electrical accessories are turned off , connect the car
charger.
1
2
1. Connect the hardwire cable to the
Dash Cam as in fi gure 1.
2. Refer to the Installation Guide for
Hardwiring the Dash Cam and fi tting
instructions..
• The hardwiring cable must be professionally installed to the vehicle by a
trained mechanic.
• Use the authentic Brigade Hardwiring Cable. Use of third party power
cables may damage the product and result in electrical fi re or electrocution
due to the voltage diff erence.
• Do not cut or modify the power cable yourself. Doing so may damage the
product or the vehicle.
• For safe driving, ensure that the cables do not obstruct driver's vision or
interfere with driving.
