BRIG Eagle 6, Руководство пользователя

Страница: 25 / 36

— 25 —
EAGLE 6 2378G.01
Do not modify electrics of the boat.
Any modification, repair and planned maintenance may
be made by authorized representative specialists only.
Do not touch the electrical equipment with wet hands.
When leaving the boat,
remember to disconnect
the batteries.
PREPARATION FOR EXPLOITATION.
In order to set the boat in the operation condition perform as follows:
— unfold the inflatable tube;
— mount the outboard motor on the transom in accodance with it's own installation instruction (manual of your outboard engine).
The inflatable tube of the boat has five independent air-tight chambers. Before inflation it's necessary to set all valves in operating
condition. In order to switch valve in operating condition, please press spindle 6 (Fig. D3) with your finger and rotate it clockwise until
the spindle will be fixed. If this operation isn't possible, it means the valve already has been set in operating condition.
Fill the tube with air using the pump from the complete set. First fill two rear chambers, next two middle chambers. However, do not
increase the pressure up to its operating value (the tube will be completely straightened). After that, please fill the fore chamber up
to the rated pressure. The rated pressure value is 0.15 bar (2.2 psi). Having completed filling, close the valve covers.
In order to discharge air from the tube chambers, open the valves (please press spindle 6 (Fig. D3) with your finger and rotate it
anticlockwise until the spindle will be fixed).
l
I
NFLATION/DEFLATION OF THE BOAT TUBE.
The rated pressure value is 0.15 bar (2.2 psi).
If the tube pressure more than nominal, deflate the tube slightly. Boat exploitation with
board pressure more than nominal decreases boat service life.
Do not use compressors and/or other types of inflating equipments not approved by the
boat builder.
Check the tube pressure before every navigation.