Simple Mail Transfer Protocol (SMTP)
for information on SMTP settings.
To enable email alerts on the Gateway, select the
Enable Email Alerts
checkbox. The two following
fields should then be completed:
Recipient Email Address
The email address/addresses to which the emails will be sent. Multiple
email addresses can be specified, separated by a semicolon, e.g.:
[email protected]; [email protected]
.
Trigger Event Log Level
The minimum log level to trigger an email. Events of higher urgency
than the selected level will also trigger an email. The available levels are, in descending order
of urgency:
Critical
Example: The Gateway is running at non-recommended temperatures.
Error
Example: A device attached to the Gateway has been disconnected.
Warning
Example: An invalid configuration file was uploaded.
Confirm these settings by clicking
Save
.
The
Test
button will send a test email to the recipient email address/addresses to confirm that the
email configuration is working correctly.
Simple Mail Transfer Protocol (SMTP)
This section allows an SMTP server to be configured, to send emails on behalf of the Gateway.
The fields in this subsection are:
SMTP Server
To enable an SMTP server, enter its IP address or hostname in this field. It must be
reachable from the Gateway’s Management interface (or whichever port the default route is
set to) on this address.
Sender Email Address
The address from which emails will be sent. This needn’t be a previously
in-use address; it can be anything your SMTP server will allow. This can be used to identify
the emails from this Gateway.
Must be of the form:
@
.
SMTP Username
Username credential to be used to send emails from the SMTP server. May be
blank, depending on your server’s configuration.
SMTP Password
Password credential to be used to send emails from the SMTP server. May be
blank, depending on your server’s configuration.
Click
Save
to apply any changes made to the SMTP configuration.
26
Содержание Oresund FCE102200
Страница 64: ...64...
