INSTALLATION SCHEME
FOR THE FOLLOWING MODELS:
BASIC-FLOOD-10W, -20W, -30W, -50W
LED Flood Light
BASIC-FLOOD-10W, -20W, -30W, -50W
Information and Safety Instructions
• Installation and maintenance should be performed by a qualified electrician.
• Before use, please read the following instructions carefully in order to avoid any damages.
• The mentioned voltage of 100-264V AC 50/60Hz should comply with the voltage of your
electricity system. If this is not the case, do not connect the projector.
• Please perform all installation and maintenance tasks with clean hands.
• The projector is designed for indoor and outdoor use, with an IP65 protection rating.
•
Caution: avoid looking directly at the LED light source in order to avoid blindness
.
Projector Installation
Caution: Always make sure that the power is turned off at the electrical panel before
starting the assembly!
I. Projector Installation
1. Carefully unpack the projector and put it on a soft and flat surface.
2. Remove the mounting bracket from the projector by unscrewing the side bolts. Keep the
bolts.
3. Install the mounting bracket at the chosen location by using appropriate screw anchors
(not included).
4. Attach and adjust the projector on the mounting bracket by using the side bolts.
IIa.
Plug-in Connection (by default)
• Insert the projector’s plug into a 110V AC socket.
IIb. Hardwire connection (optional)
a. If there is no junction box, install one (not included). Remove the bolts from the junction
box, keep them. Open the junction box.
b. Install waterproof electrical connectors (not included), one for the power supply and one
for the projector.
c. Remove the plug from the projector’s cable. Connect the green wire (ground) of the
projector to the green or bare copper wire of the junction box. Connect the white wire
(neutral) of the projector to the white wire of the junction box. Connect the black wire
of the projector (L) to the black wire of the junction box.
d. Reinstall the junction box cover. Make sure that the weatherproof gasket is properly set
in place.
Maintenance and Care
• If necessary, the projector can be cleaned with a clean, dry or slightly damp, cloth.
Caution:
please unplug it at least 10 minutes before cleaning. Do not immerse in water! Do not
use any solvent or chemical cleaners!
• If the projector’s cable is damaged, it should only be replaced by the manufacturer, his
service agent or a similarly qualified person in order to avoid a hazard.
3
1
2 4
Screw Anchors
Mounting Bracket
Side Bolt
Side Bolt
Projector
Cable
I
Projector
Installation
IIb
IIa
Hardwire Connection
(optional)
Plug-in Connection
(by default)
b
d
a
c
Junction
Box
Waterproof
Gasket
Waterproof
Connector
Projector
Power Supply
Power Supply
Waterproof
Connector
Box
Cover
Projector
Plug
AC Outlet
www.flexidel.com
|
1 888-653-3533
BASIC-FLOOD-10W
10
800
80
BASIC-FLOOD-20W
20
1600
80
4200K
120
°
BASIC-FLOOD-30W
30
2700
88
(Neutral White)
BASIC-FLOOD-50W
50
4400
88
Power
(W)
Luminous
Flux (Lm)
Efficacy
(Lm/W)
Colour
temperature
Projection
Angle
