Brickcom OSD-200 20xp, Руководство пользователя

Страница: 53 / 80

49
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after motion event occurs.
Check the box <Continue image upload> to upload the triggered
images during certain time or keep uploading until the trigger is off.
Select <Upload for __sec> and enter the duration in the blank. The
images of the duration will be uploaded to FTP when the motion
event occurs. The setting range is from 1 to 9999 seconds. Select
<Upload during the trigger active> to make the images keep being
uploaded to FTP during the trigger active until the event stops. Set
the Image frequency as the upload frame rate. The setting range is
from 1 frame to 15 frames.
NOTE- Make sure FTP configuration has been completed.
Refer to FTP for further details.
d. Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address
and configure various parameters. When motion is detected, event
images will be sent to the appointed e-mail address.
Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after the motion event occurs.
Check the box <Continue image upload> to upload the triggered
images during certain time or keep uploading until the trigger is off.
Select <Upload for __sec> and enter the duration in the blank. The
images of the duration will be uploading by E-mail when the motion
event occurs. The setting range is from 1 to 9999 seconds. Select
<Upload during the trigger active> to make the images keep being
uploaded to E-mail during the trigger active until the event stops. Set
the Image frequency as the upload frame rate. The setting range is