Brickcom FB-H200Np-S-WDRPro, Простое руководство по установке

Страница: 9 / 10

V. Bracket Installation
When mount the camera on a ceiling mount bracket, the bracket adapter can be taken apart from the bottom
and be mounted on the top of the camera, as the picture shows.
Screw Hole
Bracket Adapter
Camera Top View
VI. Housing Installation
When the camera works outdoor, it should be installed in a water-proof housing, explanation as follows:
1. Unscrew the snap-fit and open the cover of the housing.
2. Use a screwdriver to loosen the screws on the holder, pull the holder backward and take it from the holes.
[Note]: You only have to unscrew the screws on the holder, no need to screw them off.
3. Route the cable and screw up the PG joint. Suggest making the PG joint water-proof and dust-proof.
4. Place the holder at the bottom of the camera.
5. Install the camera and the holder in the housing.
[Attention]: Before fixing, put the camera lens close to the window of the housing without any obvious gap (gap
only enough for focus), to avoid light leak or halo.
6. Wire camera connectors to the connector board of the housing, cover the housing and lock it up.
8
Size of bracket adapter
PG Joint
5
Open the snap-fit
1
Pull the holder backward
Align to the hole,
take off the fixing board
3
4
2
Loosen screws
Screw Hole
Holder
Camera
6
Assemble fixing board
Route cables and tighten PG joint