
CONTROL PANEL
(Remote controller control panel with the same function as the unit
control panel)
ON/OFF:
Press once this button to make the unit ready for working. It will start up with
MID in 3 seconds and then revert to work under the memorized status. If for first time use, it will start
up with MID in 3 seconds and then work with LOW.
Press again this button to turn OFF.
SPEED:
Press this button to select desired fan speed, LOW
→
MID
→
HIGH
→
LOW, in turn. At the
same time can digital display 1.2.3.
SWING:
Press once this button to make horizontal swing of vertical louvers, the SWING indicator
will be displayed. Press again for fixed air direction. To directing vertical airflow, adjust the horizontal
louvers manually.
COOL:
During operation, press this button to start the evaporative cooling function, the water pump
and the UV lamp start to run; When you press this button again, the water pump and the UV lamp
stop working (first ON, second OFF). And both the water pump and the UV lamp stop working when
there is no water.
In order to avoid splashes of water when the panel is dry, the operating procedures of the water
pump and the motor are the following, the water pump will work intermittently for 3 minutes, after 3
minutes it will work normally; The motor will run at low wind speed for 3 minutes, after 3 minutes it
will resume operation with the previously set wind speed.
TIMER:
It can be set between 24 hours, increased by 1 hours intervals.
Water shortage detector.
After 5 seconds from pressing the "Cool" button, the water shortage detector activates. In case of
lack of water, the water pump will stop working, the "COOL" indication light will start to flash and will
cause the "Beep" to sound, for 30 seconds per cycle.
At this point, fill the water tank. The flashing light and the "Beep" sound will stop. Press the "Cool"
button again to restart the cooler.
If you do not fill the tank with water, the light will continue to flash, while the "Beep" sound will stop
after 5 minutes.
7