2
Warning
Please use the machine only if below conditions are met.
- Keep children away
- Do not touch the sealing rollers, chuck, can or can adaptor by hand while in operation.
- The machine needs a dry environment, and do not let liquids get into the machine.
- Power requirements: 220-230V, 50/60Hz, 10A fuse.
- The power supply should be grounded to avoid the danger of electric shock.
- Do not open the back cover of the machine, there is a risk of electric shock.
- Do not change the power line connection, which may cause fire, electric shock or malfunction. If
other power connector is needed, use adaptor or let licensed electrician change it.
- Do not place other items on top of the machine, to avoid any damage.
- The machine should be placed on a solid surface before starting sealing cans.
- Always sanitize all cans and lids using for example Sanipro or Starsan sanitizer before use.
How to Use
1.
After unpacking the machine and putting it on a stable surface, remove the plastic bag from
the Center Turntable Unit where the Brewly 500ml Standard Can Adaptor, Turntable, Turntable
Nut and Lever are located.
Please note: If you have another Brewly Can Adaptor (not included), for example Brewly 330ml
Standard, 440ml Standard or 330ml Sleek, it should be placed inside the 500ml adaptor (used as
base) to fit that particular can size. Example: If you have a Brewly 330ml Sleek Can adaptor,
place it inside the 500ml Standard can adaptor that is supplied with the can sealer.
2.
Plug in the power plug and turn on the can sealer using the Power Switch located on the top
back of the machine.
3.
Fill a can with a liquid of your choice and put the can lid on (sanitize can and lid before use).
4.
With the Lever in its lower position, put the can into the Can Adaptor, and pull the Lever up
until it locks in into its upper position.
5.
When the can is firmly locked in place and cannot move up or down, press the START Button.
The can will now be sealed.
Note: Do not press the STOP button to stop, it should only be used
to Emergency Stop if something goes wrong.
6.
Done! When the can sealer has finished sealing the can, grab the can with one hand and
release the can by pulling the Lever down to its lower position with the other hand.
Seam Quality Check
Check the seam quality on the first finished can. Over a sink, hold the can upside down and
squeeze the sides of the can and check for bubbles or leaks along the lid seam. If seam is good,
the continue with the next can. If the can seam is not good, please see “Adjust Turntable Height”
on the next page and follow the instructions.
Reset Counter
When the machine power is switched OFF, press and hold the STOP-button and turn ON the
machine power at the same time. Now the counter will be reset to 0. Release the STOP-button.
STOP-button
The STOP-button is an
emergency button
. It should only be pressed if there is a need to abort
the sealing process. When pressed during operation, the rollers stop immediately. To reset this
position, press STOP again, and power OFF and ON the machine. When ON again, press the
START-button, and the rollers will return to their original resting position.
