Breville LAP300, Инструкция

Страница: 9 / 16

9
Functions
OPERATING YOUR AIR PURIFIER
1. Press the POWER button to turn on and
the On/Filter reset light will illuminate.
2. The air quality sensor light will illuminate,
usually starting with a blue light until it has
time to sense the air quality and then it may
change to an alternate colour.
3. To adjust how the air purifier operates, follow
the directions below.
NOTE
The filter reset light will blink continuously
indicating that the filter needs to be replaced.
To reset the indicator after the filter has been
replaced, press and hold the POWER
button for 5 seconds and the filter reset light
will turn off.
SensAir
TM
LIVE PURITY CONTROL
• Your Breville Smart Air
TM
Purifier has a
built-in air quality sensor to detect changes
to air quality in the surrounding area.
• The SensAir
TM
light around the control panel
will change colours according to the quality of
the surrounding air.
Microbe Shield
TM
/NIGHT MODE
The Microbe Shield
TM
and Night Modes utilise
the same button on the control panel. Pressing
the Microbe Shield
TM
/NIGHT button
will cycle through these two settings.
Microbe Shield
TM
• Press the Microbe Shield
TM
/NIGHT mode
button until the Microbe Shield
TM
indicator
light illuminates to turn it on.
• Press again until the light extinguishes to
turn off this function.
Night Mode
• To turn on Night Mode, press the Microbe
Shield
TM
/NIGHT button until
the night indicator light starts to blink.
• After 10 blinks, all indicator lights on
the control panel will turn off as the unit
enters night mode and the fan speed will
automatically change to Low.
• Press any button on the control panel to
re-engage the control panel and turn off night
mode. The indicator light will extinguish.
FAN SPEED/TURBO MODE
NOTE
The air purifier will resume in the last
programmed setting once it has been turned
off, even if turned off at the power outlet. If the
last programmed setting was Night mode, once
turned on, the control panel will illuminate with
the Night indicator light blinking as a reminder
that Night mode has been set.
• Press the FAN SPEED button repeatedly
until the desired speed is illuminated on the
control panel.
• There are 4 fan speeds: Low, Medium, High
and Turbo.
• The purifier has reached Turbo mode when
all three lights are illuminated on the control
panel at the same time.
NOTE
When changing the fan speed, the unit may
take a few seconds to adjust.
TIMER
• The air purifier can be set to operate for
timed intervals of 2 hours, 4 hours and 8
hours, stopping automatically when the
selected operating time has elapsed. If no
timer is set, the air purifier will continuously
operate until it is manually switched off.
LAP300_ANZ_IB_C19.indd 9 19/3/19 4:07 pm