Breville Flow Series, Руководство пользователя

Страница: 5 / 8

5
TOASTING TIPS
• Toasting is a combination of drying and cooking
the bread and, because moisture levels differ
from one bread to another, toasting times can
vary.
• For slightly dry bread, use a lower setting than
normal.
• For fresh bread or whole wheat bread, use a
higher setting than normal.
• Bread which has a very uneven surface will
require a higher setting.
• Thicker cut pieces of bread (including crumpets)
will take longer to toast—sometimes significantly
longer. This is because more moisture must be
evaporated from the bread before toasting can
occur. Very thick pieces of bread may require
two toasting cycles.
• When toasting raisin or other fruit breads,
remove any loose raisins or fruit from the
surface of the bread before putting it into your
toaster. This will help prevent fruit pieces from
falling into your toaster or sticking to the guard
wires in the toasting slot.
SINGLE SLICE TOASTING
If you are toasting a single slice of bread, set the
browning control to a lower setting than normal. By
using a lower setting when toasting a single slice of
bread, it will not be over toasted.
IF YOUR TOASTER JAMS
Never use a knife or any other
utensil or implement to remove jammed
bread. Never insert your fingers into the
bread slots.
1. Switch the toaster off at the mains supply socket
and unplug it.
2. Allow the toaster to completely cool down.
3. Carefully ease the bread out of the toaster being
careful not to damage the heating element.
CLEANING
Always switch off, unplug and allow
the toaster to cool down before moving,
cleaning or storing. Never immerse the
toaster or power cord and plug in water
or any other liquid.
• Clean the outside of your toaster with a damp
cloth then dry thoroughly.
• Never use harsh, abrasive or caustic cleaners.
CRUMB REMOVAL
It is important that crumbs are not
allowed to build up inside your toaster.
Excess crumbs are unhygienic and
could catch fire.
Crumbs can be removed by sliding the crumb tray
out from the bottom of your toaster. You can then tip
the crumbs out. Always make sure that your toaster
has completely cooled down and is disconnected
from the mains supply before removing crumbs.
Never use your toaster without the crumb tray fitted.
Always replace the crumb tray before using your
toaster.
AFTER SALES SERVICE
These appliances are built to the very highest of
standards. There are no user serviceable parts.
Follow these steps if the unit fails to operate:
• Check the instructions have been followed
correctly.
• Check that the fuse has not blown.
• Check that the mains supply is functional.
If the appliance will still not operate, return the
appliance to the place it was purchased for a
replacement. To return the appliance to the