25
CLEANING THE TAMP SYSTEM
1
Remove
tamp cover
2
Clean the chute
with brush
3
Push down lever
4
Release lever
5
Replace
tamp cover
•
Remove the tamp cover.
•
Brush clean the tamp face and cradle from
any dust or grinds.
•
Push down and hold the lever down, using
the tamp cleaning brush, dust off grind
residues in and around the tamp.
•
Slowly release the lever back up making sure
the cleaning brush is clear and out of the
tamp system area.
CLEANING THE STEAM WAND
•
The steam wand should always be cleaned
after texturing milk. Wipe the steam wand
with a damp cloth. Then with the steam wand
tip directed over the drip tray, briefly set the
STEAM / HOT WATER dial to the STEAM
position. This will clear any remaining milk
from inside the steam wand.
•
If any of the holes in the tip of the steam
wand become blocked, ensure the
STEAM / HOT WATER dial is in the
STANDBY position. Press the POWER
button to switch the machine off and allow
to cool. Use the pin on the end of the
provided cleaning tool to unblock the hole(s).
•
If the steam wand remains blocked, remove
the tip using the integrated spanner in the
cleaning tool and soak in hot water. Use the
pin on the end of the provided cleaning tool
to unblock the hole(s) before re-attaching to
the steam wand.
CLEANING THE FILTER BASKETS
AND PORTAFILTER
•
The filter baskets and portafilter should be
rinsed under hot water immediately after use
to remove all residual coffee oils.
•
If any of the holes in the filter basket become
blocked, use the pin on the end of the
provided cleaning tool to unblock the hole(s).
•
If the hole(s) remain blocked, dissolve
a cleaning tablet in hot water and soak
filter basket and portafilter in solution for
approximately 20 minutes.
•
Rinse thoroughly.
CLEANING THE SHOWER SCREEN
•
The group head interior and shower screen
should be wiped with a damp cloth to remove
any ground coffee particles.
•
Periodically purge the machine. Place an
empty filter basket and portafilter into the
group head.
•
Press and hold the 1 CUP button and run
a short flow of water to rinse out any
residual coffee.
CLEANING THE DRIP TRAY
& STORAGE TRAY
•
The drip tray should be removed, emptied
and cleaned at regular intervals, particularly
when the drip tray full indicator is showing
EMPTY ME!
•
Remove the grid from the drip tray. Lift the
coffee grind separator and dispose of any
coffee grounds. The EMPTY ME! indicator
can also be removed from the drip tray by
pulling upwards to release the side latches.
Wash all parts in warm soapy water with
a soft cloth. Rinse and dry thoroughly.
•
The storage tray (located behind the drip
tray) can be removed and cleaned with a soft,
damp cloth. Do not use abrasive cleansers,
pads or cloths which can scratch the surface.
NOTE
All parts should be cleaned by hand using
warm water and a gentle dish washing liquid.
