13
Heating Mode
Your purifier fan heater has 2 heat settings
LOW and HIGH and allows you to set
your desired temperature with the default
temperature setting at 25°C.
1. To choose between these heat settings,
press the
button found on the control
panel or button found on the remote
control repeatedly, until the desired setting
illuminates on the LED display screen.
2. To cancel a heat setting, press the
button to stop operation. If the operation is
stopped, the unit will enter standby mode
and the LED display screen will illuminate
‘OFF’ whilst the unit is cooling down.
WARNING
To avoid overheating, do not cover the heater.
Set Temp
Take control of your room temperature.
Everyone's comfort levels are different, so you
can set your own preferred temperature or even
heat the room before you go to bed.
1. To set the desired temperature, press and
hold the
button found on the control
panel or press and hold for 3 seconds the
button found on the remote-control.
2. To increase the temperature press
button repeatedly on the control panel or
button repeatedly on the remote control.
3. To decrease the temperature press
button repeatedly on the control panel or
on the remote control.
4. Once the temperature has been set, the
LED display screen will illuminate the
room ambient temperature. The purifier
fan heater will maintain the room ambient
temperature to the temperature setting
automatically.
NOTE
Choose the heat setting to determine to
determine how quickly purifier fan heater will
maintain the set temperature setting.
NOTE
When the purifier fan heater is turned on from
standby, the memory function will start heating
based on the previously set temperature and
heating setting.
NOTE
When operating the purifier fan heater
remotely in heat mode, the purifier fan
heater will automatically switch off after 7hrs
by default.
NOTE
The purifier fan heater will stop heating
when ambient temperature is greater than set
temperature (e.g. ambient < set temperature
25
˚
C). Ambient temperature will flash and
the LED display will stay the same and
oscillation will stop.
The unit will start heating again when ambient
temperature is less than set temperature (e.g.
ambient temperature < set temperature 25
˚
C).
Ambient temperature will stop flashing and
oscillation will resume at the same angle as
previously set, only if the oscillation button
is pressed on the control panel or on the
remote control.
Night Mode
Your purifier fan heater is fitted with a light-
sensitive sensor that will intelligently stop the
LED display screen from illuminating at night
when in a dark place.
The Night mode will automatically turn off all
lights on the LED display panel and operate in
the last setting.
Press any button on the control panel
or remote control to re-engage the LED
display panel.
LPH408_ANZ_IB_D21_FA.indd 13
LPH408_ANZ_IB_D21_FA.indd 13
29/1/21 11:07 am
29/1/21 11:07 am
