1
STEP 1
2
STEP 2
3
STEP 3
1) Side Chair with Cane Insert
2) Side Chair with Wood Trim and Cushion Insert
3) Counter Stool / Bar Stool with Cane Insert
4) Counter Stool / Bar Stool with Wood Trim and Cushion Insert
NOTE: Assembly process is the same with all four configurations.
Place your seat upside down on a
flat surface (edge of a table or
counter). Position your side chair
frame over the marked indentations.
Note: Bevel edge of seat with
authenticity / branding sticker is
the front of seat. The front of the
seat is the flat end with the bevel
edge. Start on right side and attach
the two screws and then move to the
left side. One the left side assistance
will be needed in flexing the frame
(sometimes with force) to center
over marked indentations while
assembly person #1 is ready with
screws. Tighten all screws until the
metal frame is touching the wood.
Please locate top of backrest and
position the backrest facing up. You
will see color codes on screw (A)
which will match the color code on
the back of the frame to verify the
backrest is positioned correctly.
Place the backrest against the
frame, screw in the top hole first (A)
and then the bottom hole (C). (Do not
tighten the screws until both screws
are in halfway).
Once tightened move to the other
side to attach the two remaining
screws. First start with top (B) and
than move to the bottom (D). Note:
Assembly person no. 2 will need to
help to pull/adjust and flex the top
two metal back posts of chair frame
towards each other as needed.
Tighten all screws until the metal
frame is touching the wood.
(Caution : Do not over tighten screws)
THIS ASSEMBLY IS FOR:
www.breuerchaircompany.com
PAGE 3
BREUER CHAIR ASSEMBLY INSTRUCTION
Thank you for choosing Breuer Chair as part of your home.
TOOLS NEEDED:
(A)
(C)
(B)
(D)
We recommend using an impact driver handgun power tool. If
using a drill/driver gun please set the torque to the lowest
setting and increase torque as needed. (2 person assembly
recommended). When attaching the seat and back you will need
to use your body weight to get the screw into the seat and back.
The wood used is commercial grade solid Italian beech wood
which is a very dense wood that does not want to accept the
screw. There are no pre-drilled holes on the seat and no need to
make pre-drilled holes. There are markers of where the screws
need to go and simply go right into the wood at those marker
points. Hand assembly with a Philips screwdriver is possible
although it will require more time and pressure/force to get the
screws attached. Save all packaging until assembly is completed.
When assembling your chair ALWAYS INSTALL THE BACK FIRST
before installing the seat.
BEFORE BEGINNING ASSEMBLY:
ACTUAL BACK AND SEAT:
(Blue Dot)
Top of Backrest
Front of the Seat
Back of the Seat
(A)
(B)
(D)
(C)
