Bresser BR-D1200BL, Инструкция по эксплуатации

Страница: 10 / 28

10 / 28
3. Rotate the adjustment knob to the right (+) to increase the respective value. Rotate the adjustment
knob to the left (-) to decrease the respective value.
9 Changing the lighting angle
1. Carefully loosen the locking knobs on both sides of the U-mount.
2. Move the light to the desired angle.
3. Hand-tighten the locking knobs again.
DANGER! Allow the housing surface to cool down before touching it! Touching hot components
can cause serious burns.
WARNING! Hold the light when the locking knobs have been loosened to avoid damage to the
panel!
10 Connection with an lighting console (DMX-RJ11)
(optional)
One or more LED lights can be controlled centrally when connecting them with a RJ11 compatible
lighting console* through suitable connection cables*.
1. Insert the RJ11 modular plug of the connection cable* into the corresponding socket on the lighting
console* and into the socket of the LED light.
2. Press the control selection knob to enable control via DMX lighting console. The DMX function
lamp lights up.
NOTICE! In DMX control mode, the LED light can be controlled only through the console.
3. For the manual control or remote control*, press the control selection knob again. The 2.4G func-
tion light will light up.
*not included
11 Remote control (optional)
The device can be controlled with a suitable 2.4GHz remote control* over the built-in receiver. When
using the same channel, different devices can be operated at the same time through the rermote con-
trol*.
To control the device through a remote control, proceed as follows:
1. Turn on the device(s).
2. Set the desired receiving channel to all lights being controlled.
3. Set the channel also for the remote control.
NOTICE! Only use the remote control recommended for this type of light! If a light is not to be
controlled synchronously, simply change the channel on the corresponding light.
*not included
12 Setting a channel for remote control
1. Press CHANNEL button to enable the channel setting. Two digits flash on the display (currently
set channel).
2. Rotate the adjustment knob to the right (+) to increase the value. Rotate the adjustment knob to
the left (-) to decrease the value.
3. Once the number on the display does not flash anymore the new channel value has been saved.