13 / 40
4.
Wait until the indoor temperature is displayed on the
base station.
Remote sensor
5.
Remove the battery compartment cover.
6.
Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
7.
Move the CH slide control to the position for the desired
transmission channel (setting CH1, CH2 or CH3 with
screen display).
8.
Replace the battery compartment cover.
NOTICE! When operating one outdoor sensor, channel 1
is recommended as the default setting.
9 Automatic time setting
After the powering it on, the unit automatically searches for
the radio signal. It takes about 3-8 minutes to complete this
process.
If the radio signal is received correctly, the date and time
are set automatically and the reception symbol is displayed.
If no radio signal is received, proceed as follows:
1.
Press the RCC button for approx. 2 seconds to initiate
the reception of the radio signal again.
2.
If no radio signal is still received, the time must be set
manually.
10 Manual time setting
1.
In normal display mode, press the MODE button for
about 3 seconds to enter the time settings mode.
