Breezair TBA 550, Руководство по установке

Страница: 9 / 20

Attach the drain Adaptor under the Drain Valve
and attach a pipe to carry the water to a suitable
drain point.
Do not allow water to run freely
onto the roof - it will stain the roof!! See
Diagram.
The Water Sensor protects the pump and helps
control water salinity.
Fit the Water Sensor as shown by clipping it to
the Water Tank. See Diagram. Make sure the clip
engages fully. Route the sensor cable through the
cable supports in the Water Tank as shown. See
diagram. It will be connected later.
If you have installed the drain valve, then fit
the float valve and solenoid valve to the air cooler
as shown.
Make sure all washers and o-rings are fitted
correctly.
Do not over-tighten plastic threads!!
Make sure the Float Valve is centrally positioned
and is free to move up and down.
Screw the Solenoid Valve into the extension tube.
Check the direction of water flow with the arrow
on the back of the valve . See diagram.
Make sure Solenoid Valve seals against the rubber
washer on the Extension Tube. Twist the Solenoid
Valve so that the cover will fit on OK.
Connect the solenoid cable (supplied in the kit)
to the Solenoid Valve. Route the cable through
the hole in the Transition. See diagram. The other
end will be connected later.
IMPORTANT: Make sure the cable does not
interfere with the Weatherseal and that it will
not be crushed by the Venturi/fan assembly.
Clip the solenoid cover into place under the air
cooler. Then screw the flexible water hose (supplied
in the kit) onto the Solenoid Valve. Make sure the
rubber washer seal is in place.
Important: take care when connecting the
flexible water hose to the solenoid valve or
the float valve adaptor. The threads may
become crossed and the connection will fail.
7