25
Chapter 4: Assembling the Bed Face Panel unit.
The position of the frame on the doors is critical and will lead to
problems further on during the assembly. Review Chapter 4, Step 3.
Do you have a 1/2” setback along
the mechanism end?
If you have any question, contact us (phone:
1-855-466-4781
, email:
service@
bredabeds.com
or live chat:
https://bredabeds.com
) before proceeding.
Is the bed securely attached to the wall?
Review Chapter 3, Step 4 and the warnings on that page.
Review Chapter 4, Step 2, Fig 4C and Fig 4D
Is the Leg Stop Cylinder installed
in the bottom hole at the leg end?
Review the Spring Application Chart in Chapter 1, Step 5. Even though
we have this chart, the bed will still need to be adjusted due to varying
mattress weights later in assembly during Chapter 7, Step 3.
Do you have the correct quantity
of springs installed?
Each hole along the frame and stiffeners must have a screw at this point
and all available stiffeners installed. The frame will pull away from the
doors if this is not done. Review Chapter 4, Steps 3 and 4.
Have you inserted screws at each
hole in the frame and stiffeners?
Is the work area clear of children & pets?
STOP
*** STOP - SAFETY CHECKLIST ***
The items listed on this page are some of the most common errors during assembly
and can lead to structural failure of the Murphy Bed if not done properly.
DO NOT PROCEED PAST THIS PAGE WITHOUT FIRST VERIFYING THE FOLLOWING: