21
Chapter 3: Attaching the Bed Cabinet to the wall.
FIG. 3B - LOOKING UP AT THE NAILER/COVER FROM BELOW
Attach the “
Top Nailer Cover
” using the 1-1/4” screws from
Hardware Package #10 through the pre-drilled holes in the
cover piece. One side of the cover has recessed holes which
is the front and one edge is finished which is the bottom. The
quantity of screws used will vary depending on bed size. Cover
screw heads with stickers from Hardware Package #10.
STEP 5
DO NOT REMOVE THE CAUTION TAPE/STICKER ON THE
TOP NAILER. THIS TAPE CONTAINS IMPORTANT SAFETY
INFORMATION FOR DISASSEMBLY.
Locate 2 holes in the middle of the
“Mid Shelf”
on the top
side and insert 2 cam screws from hardware package #1.
Place the
“Bed Cabinet Vertical Divider”
inside the top
hutch, with the clean edge banded side facing out. You may
have to tilt the panel slightly as shown in Fig. 3D to get it
into place. Once vertical, tighten all 4 cam fittings.
STEP 6
FIG. 3D
Mid Shelf
FIG. 3C
