BRAYER BR4206, Инструкция по эксплуатации

Страница: 11 / 48

11 EN
• Remove the filter block (11) (pic. 14).
• Turn the dust bin (13) flask clockwise and remove it,
turn the ring (26) clockwise and remove it, remove
the separator (27) by turning it clockwise (pic. 15).
• Wash the separator (27), the ring (26), the dust bin
(13) flask and the filter block (11) under a warm water
jet and dry them (pic. 16, 17).
• Do not wash the parts in a dishwashing machine.
• Thoroughly dry all the parts of the dust bin (13).
• Dry the filter (19) thoroughly.
• Assemble the dust bin (13) in reverse sequence (pic.
18).
• Install the assembled dust bin (13) back to its place,
make sure that the dust bin (13) is fixed properly.
Attention! Before assembling and installing the dust bin
(13) back to its place, make sure that the filter (11), the
separator (27) and the flask (13) are dry.
Cleaning the outlet filter (4)
• Switch the vacuum cleaner off and unplug the power
cord plug from the mains socket.
• Remove the grid (3) of the outlet filter (4) by pressing
the clamp, remove the outlet filter (4) (pic. 19).
• Remove the outlet filter grid (4), turning it clockwise
and remove the outlet filter (4) (pic.19).
• Wash the outlet filter (4) and the grid (3) under a
lukewarm water jet. Do not wash the outlet filter (4)
and the grid (3) in a dishwashing machine.
• Dry the outlet filter (4) and the grid (3) (pic21).
• Do not dry the filter (4) with a hairdryer or similar
appliances.
• Install the outlet filter (4) back to its place.
• Install the grid (3) back to its place, turn the grid (18)
counterclockwise as far as it will go.
Vacuum cleaner body
• Clean the vacuum cleaner body with a soft, slightly
damp cloth, and then wipe it dry. Provide that no
liquid gets inside the vacuum cleaner body.
• Do not use solvents or abrasives for cleaning the
vacuum cleaner body and the attachments.
• Do not immerse the vacuum cleaner body, the power
cord and the power plug into water or any other
liquids.
OVERHEATING PROTECTION
• If the electric motor gets too hot during the operation,
the overheating protection system will be set off.
• If during cleaning the vacuum cleaner has switched
off, press the on/off button (8) and unplug the unit.
• Let the vacuum cleaner cool down for 30-40 minutes
and switch it on again. The cool-down time can
differ from the given value, depending on the room
temperature.
• If the vacuum cleaner does not switch on, it may be
caused by another malfunction. In this case apply to
a service center.