BRAYER BR4004, Инструкция по эксплуатации

Страница: 6 / 44

6 EN
and apply to the service center.
• To avoid damages, transport the unit in the original
package.
• Keep the unit in a dry cool place out of reach of
children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL
OR LABORATORY PURPOSES.
BEFORE THE FIRST USE
After the unit’s transportation or storage at negative
temperature, unpack it and wait for at least 3 hours
before using.
• Unpack the iron and remove any packaging materials
and advertising stickers.
• If there is a protective film on the soleplate (11),
remove it.
• There may be water residue in the tank (10), as the
iron has undergone factory quality control.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
• Make sure that specified specifications of power
supply voltage of the unit correspond to the
specifications of your mains. When using the unit in
the mains with 60 Hz frequency, the unit does not
need any additional settings.
• Clean the iron body and the soleplate with a soft,
slightly damp cloth and then wipe it dry.
WATER SELECTION
• Use tap water to fill the water tank (10) of the iron.
• If tap water is hard, it is recommended to mix it with
distilled water in proportion 1:1. If tap water is too
hard, mix it with distilled water in proportion 1:2 or
use distilled water only.
FILLING THE WATER TANK
ATTENTION!
Before filling the water tank (10) with water make sure
that the iron is switched off and unplugged.
• Set the temperature control knob (12) to the position
«MIN», and the continuous steam supply knob (4) to
the position « ».
• Open the water inlet lid (2).
• Pour the water into the water tank using the beaker
(10) and then close the lid (2).
Notes:
– do not let water go over the «МАХ» mark when filling
the water tank (10);
– if you need to refill the water tank during ironing,