BRAYER BR1090, Инструкция по эксплуатации

Страница: 12 / 52

12 EN
stains do not affect the operation of the thermopot,
stains are not covered by the warranty.
• You can remove the stains from the inner surface of
the thermopot flask with citric acid solution or table
vinegar.
• To remove the flavour of citric acid or vinegar, boil
water and pour it out.
• Repeat this procedure until the smell and foreign
taste vanish completely.
Removing the mineral deposits (descaling)
• Scale, appearing inside the thermopot flask,
influences the water taste and disturbs the heat
exchange between water and the heating element.
It also risks damaging the heating element. Burning
of the heating element caused by the large amount
of scale in the thermopot flask is not covered by
warranty.
• To remove the scale fill the thermopot with a mixture
of one part ordinary vinegar and two parts water up
to the maximal level mark «FULL».
• Insert the power cord (8) plug into the mains socket.
• Switch the thermopot on in the water boiling mode.
After water boiling switch the thermopot off, to do
this, press and hold the button (12) «Start/re-boil» for
5 seconds, take the plug of the power cord (20 8) out
of the mains socket and leave the thermopot with the
vinegar solution overnight.
• In the morning pour out the vinegar solution, fill the
thermopot with water up to the maximal level, boil it
and pour out the water.
• You can use special descaling agents for electric
kettles, strictly following the instruction.
• Clean the thermopot from scale regularly.
STORAGE
• Before taking the thermopot away for long storage,
disconnect it from the mains, let the unit cool down
and pour out the water.
• Clean the thermopot.
• Keep the thermopot out of reach of children and
disabled persons.
DELIVERY SET
1. Thermopot – 1 pc.
2. Manual – 1 pc.
ECHNICAL SPECIFICATIONS
• Power supply 220-240 V, ~ 50-60 Hz
• Rated input power: 1200 W
• Water tank capacity: 5 l