E N G L I S H | 6
WA R N I N G S , C A U T I O N
& L E G A L I N F O R M AT I O N
To reduce the risk of fire or electric shock, do not expose
the BRAVEN to rain or moisture while charging. The
BRAVEN should not be exposed to dripping or splashing,
and objects filled with liquids, such as vases, should not
be placed on or near it while being charged or charging
other devices. As with any electronic products, use care
not to spill liquids into any part of the product. Liquids
can cause a failure and/or a fire hazard. The power supply
must be used indoors only. Make no modifications to the
product or accessories. Unauthorized alterations may
compromise safety, regulatory compliance, and system
performance, and will void the warranty. Do not place
any flame sources, such as lighted candles, on or near
the BRAVEN. The BRAVEN contains small parts that
may be a choking hazard and is not suitable for children
under age 3. Do not continue charging the battery if it
does not reach full charge within the specified charging
time. Overcharging may cause the battery to become hot,
rupture, or ignite. If you see any heat deformation or
leakage, properly dispose of the battery. Do not attempt
to charge the battery in temperatures outside the range
of 32°-104°F (0°-40°C). If the battery begins to leak, do
not allow the liquid to come in contact with your skin
or eyes. If contact has been made, wash the affected
area with plenty of water and seek medical attention
immediately. Do not expose the product or battery to
excessive heat, including direct sunlight or fire and
storage or use inside cars in hot weather, where it can be
exposed to temperatures in excess of 115°F (60°C). Doing
so may cause the battery and power supply to generate
heat, rupture, or ignite. Using the product in this manner
also may result in a loss of performance and a shortened
life expectancy. Extended exposure to direct sunlight
may damage the external appearance and material
qualities. Do not step on, throw, or drop batteries or
the power supply or device, or expose them to a strong
shock. Do not pierce, crush, dent, or deform the batteries
or power supply in any way. If either becomes deformed,
properly dispose of it. Do not short-circuit batteries. Do
not attempt to service the BRAVEN yourself. Opening or
removing covers may expose you to dangerous voltages
or other hazards and will void the manufacturer’s
warranty. To prevent risk of fire or electric shock, avoid
overloading wall outlets, extension cords, or integral
convenience receptacles. Your Bluetooth device (mobile
phone, music player, tablet, laptop, etc.) must support
the A2DP Bluetooth profile in order to work wirelessly
with your new BRAVEN speaker. The A2DP profile is
supported by most recent mobile products with built-
in Bluetooth capability. Please refer to your device’s
user manual for details and instruction regarding the
Bluetooth profiles it supports. This device complies with
part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of
the following measures:—Reorient or relocate the
receiving antenna. —Increase the separation between
the equipment and receiver. —Connect the equipment
into an outlet on a circuit different from that to which
the receiver is connected. — Consult the dealer or an
experienced radio/TV technician for help.
CAUTION: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
FCC RADIATION EXPOSURE STATEMENT: This device
complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device. Under Industry Canada
regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
Lithium Battery installed is not intended to be replaced
by the USER.
CAUTION: Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type.
Where the MAINS plug is used as the disconnect device,
the disconnect device shall remain readily operable.
The device meets the exemption from the routine
evaluation limits in section 2.5 of RSS 102 and compliance
with RSS-102 RF exposure, users can obtain Canadian
information on RF exposure and compliance.
Correct Disposal of this product. This marking
indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent
possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources.
To return your used device, please use the return and
collection systems or contact the retailer where the
product was purchased.
This product complies with California Energy
Commission efficiency standards for consumer battery
chargers.
Hereby, Braven, declares that this device is in
compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU
Operating Frequency Band: 2402 MHz to 2480 MHz
Maximum RF power: 6dBm EIRP
Braven hereby declares that READY SOLO is in compliance
with Radio Equipment Directive 2014/53/EU.The full text
of the EU DoC is available at the following: https://www.
braven.com/eu-declaration-of-conformity/*****.PDF
Braven follows Safety Instruction for CE-LV. Operate
Products not more than -5~40 °C.
Do not install this equipment in a confined or building-in
space such as a book case or similar unit, and remain a
well ventilation conditions. The ventilation should not be
impeded by covering the ventilation openings with items
such as newspaper, table-cloths, curtains etc.
WARNING：To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or moisture. The
apparatus shall not be exposed to dripping or splashing
and that objects filled with liquids, such as vases, shall
not be placed on apparatus.
WARNING: The power adapter is used as disconnect
device, the disconnect device shall remain readily
operable.
WARNING：Please refer the information on exterior
bottom enclosure for electrical and safety information
before installing or operating the apparatus.
CAUTION: Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type.
The battery (battery or batteries of battery pack) shall
not be exposed to excessive heat such as sunshine, fire
or the like.
A r ticle 10
2. Manu fac t urer s shall ensure t hat r adio equipment
shall be so cons t r uc ted t hat it c an be oper ated in at
le as t one Member St ate wit hou t inf ringing applic able
requirement s on t he use of r adio spe c t r um.
10. In c ases of res t ric tions on pu t ting into ser vice
or of requirement s for au t horis ation of use,
infor mation available on t he p ackaging shall allow
t he identific ation of t he Member St ates or t he
geogr aphic al are a wit hin a Member St ate w here
res t ric tions on pu t ting into ser vice or requirement s
for au t horiz ation of use exis t. Such infor mation
shall be completed in t he ins t r uc tions ac comp anying
t he r adio equipment. T he Commission may adop t
implementing ac t s spe cif ying how to present t hat
infor mation. T hose implementing ac t s shall be
adop ted in ac cor dance wit h t he ad visor y pr o cedure
refer red to in A r ticle 45 (2).
Manu fac t urer: Br aven LC.
Содержание Ready SOLO
Страница 1: ...USER GUIDE ...
