E N G L I S H | 6
WA R N I N G S , C A U T I O N
& L E G A L I N F O R M AT I O N
To reduce the risk of fire or electric shock, do
not expose the BRAVEN to rain or moisture while
charging. The BRAVEN should not be exposed to
dripping or splashing, and objects filled with liquids,
such as vases, should not be placed on or near it
while being charged or charging other devices. As
with any electronic products, use care not to spill
liquids into any part of the product. Liquids can cause
a failure and/or a fire hazard. The power supply must
be used indoors only. Make no modifications to the
product or accessories. Unauthorized alterations
may compromise safety, regulatory compliance, and
system performance, and will void the warranty. Do
not place any flame sources, such as lighted candles,
on or near the BRAVEN. The BRAVEN contains small
parts that may be a choking hazard and is not suitable
for children under age 3. Do not continue charging
the battery if it does not reach full charge within the
specified charging time. Overcharging may cause the
battery to become hot, rupture, or ignite. If you see
any heat deformation or leakage, properly dispose
of the battery. Do not attempt to charge the battery
in temperatures outside the range of 32°-104°F (0°-
40°C). If the battery begins to leak, do not allow the
liquid to come in contact with your skin or eyes. If
contact has been made, wash the affected area
with plenty of water and seek medical attention
immediately. Do not expose the product or battery to
excessive heat, including direct sunlight or fire and
storage or use inside cars in hot weather, where it
can be exposed to temperatures in excess of 115°F
(60°C). Doing so may cause the battery and power
supply to generate heat, rupture, or ignite. Using
the product in this manner also may result in a loss
of performance and a shortened life expectancy.
Extended exposure to direct sunlight may damage
the external appearance and material qualities. Do
not step on, throw, or drop batteries or the power
supply or device, or expose them to a strong shock.
Do not pierce, crush, dent, or deform the batteries
or power supply in any way. If either becomes
deformed, properly dispose of it. Do not short-circuit
batteries. Do not attempt to service the BRAVEN
yourself. Opening or removing covers may expose
you to dangerous voltages or other hazards and will
void the manufacturer’s warranty. To prevent risk of
fire or electric shock, avoid overloading wall outlets,
extension cords, or integral convenience receptacles.
Your Bluetooth device (mobile phone, music player,
tablet, laptop, etc.) must support the A2DP Bluetooth
profile in order to work wirelessly with your new
BRAVEN speaker. The A2DP profile is supported by
most recent mobile products with built-in Bluetooth
capability. Please refer to your device’s user manual
for details and instruction regarding the Bluetooth
profiles it supports. This device complies with part 15
of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:—Reorient or relocate the receiving
antenna. —Increase the separation between the
equipment and receiver. —Connect the equipment
into an outlet on a circuit different from that to which
the receiver is connected. — Consult the dealer or an
experienced radio/TV technician for help. CAUTION:
Any changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s authority to operate the
equipment. FCC RADIATION EXPOSURE STATEMENT:
This device complies with FCC radiation exposure
limits set forth for an uncontrolled environment.
The device has been evaluated to meet the
general RF exposure requirement. The device can
be used in portable exposure conditions without
restriction. This device complies with Industry
Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device
must accept any interference, including interference
that may cause undesired operation of the device.
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
The device has been evaluated to meet general RF
exposure requirement. The device can be used in
portable exposure condition without restriction. This
Class B digital apparatus complies with Canadian
ICES-003.Lithium Battery installed is not intended
to be replaced by the USER. CAUTION: Danger of
explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type. Where the
MAINS plug is used as the disconnect device, the
disconnect device shall remain readily operable.
The device meets the exemption from the routine
evaluation limits in section 2.5 of RSS 102 and
compliance with RSS-102 RF exposure, users can
obtain Canadian information on RF exposure and
compliance.
Cor rec t Disposal of t his pr oduc t. T his
mar king indic ates t hat t his pr oduc t should
not be disposed wit h ot her household was tes
t hr oughou t t he EU. To prevent possible har m to t he
envir onment or human healt h fr om uncontr olled
was te disposal, rec ycle it responsibly to pr omote
t he sus t ainable reuse of material resour ces. To
retur n your used device, please use t he retur n
and collec tion sys tems or cont ac t t he ret ailer
w here t he pr oduc t was pur chased.
T his pr oduc t complies wit h Califor nia
Ener g y Commission ef ficienc y s t andar ds for
consumer b at ter y char ger s.
Br aven hereby declares t hat t his device is in
compliance wit h Radio Equipment Direc tive
2014/ 53/EU. T he full tex t of t he EU DoC is
available at t he following: ht tps://w w w.br aven.
com/eu-declar ation-of-confor mit y.
Br aven follows Safet y Ins tr uc tion for CE- LV. Do
not oper ate pr oduc t s in temper atures ou t side t he
r ange of - 5 - 4 0 °C. Oper ating Frequenc y Band:
24 02 MHz to 24 8 0 MHz Ma ximum RF power:
6dBm EIR P. Do not ins t all t his equipment in a
confined or building-in sp ace such as a book c ase
or similar unit, and remain a well ventilation
conditions. T he ventilation should not be impeded
by covering t he ventilation openings wit h items
such as newsp aper, t able-clot hs, cur t ains et c.
WARNINGTo r
educe t
he risk of f
ir
e or ele
c
t
ric
sho
ck
, do no
t ex
p
ose t
his app
ar
at
us to r
ain or
mois
t
ur
e. T
he app
ar
at
us shall no
t b
e ex
p
ose
d
to dripping or splashing and t
hat obje
c
t
s fille
d
w
it
h liquids, such as v
ases, shall no
t b
e placed
on app ar atus.
WARNING: T he power adap ter is used as
disconnec t device, t he disconnec t device shall
remain readily oper able. WARNING：Please refer
t he infor mation on ex terior bot tom enclosure for
elec tric al and safet y infor mation before ins t alling
or oper ating t he app ar atus. CAUTION: Danger
of ex plosion if b at ter y is incor rec tly replaced.
Replace only wit h t he same or equivalent t y pe.
T he b at ter y (b at ter y or b at teries of b at ter y p ack)
shall not be ex posed to excessive heat such as
sunshine, fire or t he like.
Ar ticle 10
2. Manufacturers shall ensure that radio
equipment shall be so cons tr uc ted t hat it c an be
oper ated in at leas t one Member St ate wit hou t
infringing applic able requirement s on t he use of
r adio spec tr um.
10. In c ases of res tric tions on pu t ting into
ser vice or of requirement s for au t horisation of
use, infor mation available on t he p ackaging
shall allow t he identific ation of t he Member
St ates or t he geogr aphic al area wit hin a Member
St ate w here res tric tions on pu t ting into ser vice
or requirement s for au t horization of use exis t.
T he Commission may adop t implementing ac t s
specif ying how to present t hat infor mation.
T hose implementing ac t s shall be adop ted in
accor dance wit h t he ad visor y pr ocedure refer red
to in Ar ticle 45 (2).
Manufac turer: Br aven LC.
Le présentappareilestconforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitationestautorisée aux deux conditions
suivantes:(1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareildoit accepter tout
brouillageradioélectriquesubi, mêmesi le brouillageest
susceptible d'encompromettre le fonctionnement.
Содержание READY PRIME
Страница 1: ...USER GUIDE ...
