Brave VH9934, Руководство владельца/оператора и по безопасности

Страница: 18 / 24

18. The log splitter is now completely assem-
bled. Follow the “Start-Up Procedure” in
the following section, which adds oil to
the engine and hydraulic tank before try-
ing to start the engine.
Brave Products, Inc.
16
815-672-8861
Hydraulic Oil Change
Brave Products recommends an oil and filter change every 100 hours of operation. Refer
to the “Specifications” section in this manual for the type and quantity of oil.
Important Notice
Never run the log splitter unless the hydraulic oil tank is full.
1. Drain the cylinder.
a. Remove the spark plug wire and spark
plug to help reduce the back pressure
on the engine and to prevent it from
starting.
b. Disconnect return hose (1) from the oil
filter housing and place it in a waste oil
container. (Please properly dispose of
the waste oil per local regulations.)
c. Extend the cylinder by holding the
valve handle forward and pulling on
the engine’s pull start cord until oil
from the return line stops flowing.
2. Drain the hydraulic tank.
a. Place a waste oil container under the
inlet hose.
b. Remove inlet hose (2) from the tank.
c. Slightly raise the front of the log splitter
to completely drain the tank.
3. Refill the hydraulic tank.
a. Reconnect the inlet hose to the pump.
b. Reconnect the return hose to the oil
filter.
815-672-8861
29
Brave Products, Inc.