29
Any Questions, Comments, Problems, or Parts Orders
Call BRAVE Product Support 1-800-350-8739
storage
Winter Storage
To protect the unit from freezing temperatures:.
1. Use Pump Saver to treat pump. This minimizes freeze damage and
lubricates pistons and seals. Contact your local dealer for Pump Saver
Solution.
2. If pump saver is not available, connect a 3 ft. section of garden hose to
water inlet adapter. Pour RV-antifreeze (antifreeze without alcohol) into
hose. Pull recoil handle twice. Disconnect 3 ft. hose.
3. Store unit in a clean, dry area (heated area preferred).
Long Term Storage
If you do not plan to use the pressure washer for more than 30 days, you
must prepare the engine and pump for long term storage.
Protect Fuel System
Fuel Additive:
Fuel will become stale when stored over 30 days. Stale fuel causes acids
and gum deposits to form in the fuel system or on essential carburetor
parts. Prior to storage, if gasoline has not been treated with a fuel
stabilizer, it must be drained from the engine into an approved container.
Then run engine until it stops from lack of fuel.
NOTICE
You must protect your unit from freezing temperatures.
• Failure to do so will permanently damage your pump and render your
unit inoperable.
• Freeze damage is not covered under warranty.
Thermal Relief Valve is
open and discharging
water from side of pump
1. Water temperature is too high
2. Pump has operated more than 3 mins
without pulling trigger
1. Use cool water only.
2. Pull trigger at least 30 seconds every 3 mins
Leak in the fittings 1. Water leak in high pressure fittings, hose
or gun
1. Use teflon tape or pipe sealant to
tighten hose fitting, replace hose or gun
**If problem continues, take to your
pressure washer dealer
Pump oil is low?
1. Normal use consumes oil over time 1. To gauge the oil level, look directly into the
sight glass. Oil level should always be at
the center dot. Do not overfill replace
w/30W non detergent mineral oil
Oil is milky color
1. Seals have worn from us and water has
leaked in
1. Bring Unit local service center to have seals
replaced