Braun SERIES 3 350CC-4, Руководство пользователя

Страница: 28 / 31

28
• The appliance contains highly flammable liquid. Keep it away from sources
of ignition. No smoking.
• Keep out of reach of children. Do not refill cartridge. Use only original
Braun refill cartridge.
Description
1 Start/release button
2 Contact bow
3 Lift button for cartridge exchange
4 Level indicator
5 Cleaning cartridge
Before using Clean&Renew
Installing the cartridge
• Press the lift button (3) to open the housing.
• Hold the cartridge down on a flat, stable surface (e.g. table). Carefully
remove the lid from the cartridge. Slide the cartridge into the base as far
as it will go.
• Slowly close the housing by pushing it down until it locks.
Replacing the cartridge
After having pressed the lift button to open the housing, wait for a few
seconds before removing the used cartridge.
Before discarding the used cartridge, make sure to close the openings
using the lid of the new cartridge, since the used cartridge will contain
contaminated cleaning solution.
The used cartridge can be disposed in the household waste.
Operating your Clean&Renew
• Connect your Clean&Renew with the cord set to the mains electricity
supply. The special socket at the back is adjustable to save space. After
each shave, switch the shaver off and put it into the Clean&Renew, upside
down and with the front showing.
• Push the start/release button (1) to lock and connect the shaver. The
cleaning process will start. The yellow light on the shaver will flash during
the complete process (approx. 2 minutes cleaning, min. 4 hours drying).
• Do not interrupt the cleaning process, as it leaves the shaver wet and not
fit for use. If interruption is needed nonetheless, press the start/release
button (1).