Braun Nescafe Nescup NC1000, Руководство пользователя

Страница: 15 / 20

16
• Dissolve descaling agent in 1.7 l water and fill
this mixture in the water tank (C) up to «max».
Please use 50 g of a descaling powder based on
amidosulphonic acid and citric acid.
• Remove the drip tray (N) and position a kitchen
container in its place (capacity 2 litres or more).
• Ensure that the coffee/water selector (Q) is in
the «water» position.
• Press the «stop» button (D) and keep it
depressed while pressing the manual button (H).
• The unit will start the descaling cycle. During
the whole descaling process power/stand-by
signal is flashing and the water filter exchange
signal is lit permanently.
2.
• After approx. 20 minutes, the process stops and
the cup, mug, cappuccino and manual signals
will blink. You need to switch the coffee/water
selector to the «coffee» position.
• In the «coffee» position, the above sequence is
repeated again until the tank (C) is empty.
3.
• Then the cup, mug, cappuccino and manual
signals will blink again. Empty the kitchen
container and place it back underneath the
pipes.
• Clean the water tank (C) and refill it with fresh,
cold water up to «max».
• To start the «automatic rinsing cycle» of the
water pipe switch the coffee/water selector to
the «water» position.
4.
• When the cup, mug, cappuccino and manual
signals blink again, start the «automatic rinsing
cycle» of the coffee pipe by switching the
coffee/water selector to the «coffee» position.
A manual coffee cycle is run every 2 minutes
until the tank (C) is empty.
• The descaling process is finished when the
power/stand-by signal is permanently lit.
Troubleshooting
Problem Situation Solution
The machine runs out of water
during brewing. Water tank (C) is empty.
Quantity in cup lower than
normal. Fill the water tank (C). Press the
cup/mug or cappuccino button
to start a new coffee.
Nothing happens when the cup
button (K), mug button (J) or
cappuccino button (I) is
pressed. No beverage delivery. Make sure that the unit is
plugged in, switched on and the
water tank (C) is full.
Cup lights are blinking one after
the other. Brewing process has been
interrupted. Check if liquid remains inside
the brewing unit. If yes, press
cup button (K) until empty. Then
press the «stop» button to reset.
Proceed as per section
«Preparing Hot Beverages».
Coffee is too weak even if coffee
selector is in «max» strength or
only hot water is coming out. 1. Coffee container is blocked.
2. Dosing tube (Y) is blocked. 1. Disassemble the coffee
container (A) and clean the
lid (see «Cleaning – Coffee
Container»). Disassemble
and clean the brewing unit
(U).
2. Remove the brewing unit
and the coffee container.
Then remove the dosing
tube (Y) and clean it in hot
water. Ensure all parts are
completely dry before re-
assembly.
3150350_Nescup_S6-24 Seite 16 Donnerstag, 6. Oktober 2005 3:05 15