9
The hygienic cleaning cartridge contains ethanol or
isopropanol (specification see cartridge), which
once opened will naturally evaporate slowly.
Each cartridge, if not used daily, should be replaced
after approximately 8 weeks to ensure optimal
disinfection.
The cleaning cartridge also contains lubricants, for
the shaving system which may leave residual marks
on the outer foil frame and the cleaning chamber
of the Clean&Charge station after cleaning. These
marks can be removed easily by wiping gently with a
damp cloth.
Accessories
Braun recommends changing your shaver’s
Foil & Cutter cassette every 18 months to maintain
your shaver’s maximum performance.
Available at your dealer or Braun Service Centres:
•
Foil & Cutter cassette: 40S/40B
•
Cleaning cartridge Clean&Charge: CCR
Environmental notice
Product contains batteries and/or recyclable
electric waste. For environment protection do
not dispose of in household waste, but for
recycling take to electric waste collection
points provided in your country.
The cleaning cartridge can be disposed of with
regular household waste.
Subject to change without notice.
For electrical specifications, see printing on the
special cord set.
Trouble-Shooting
Problem
Possible reason
Remedy
SHAVER
Unpleasant smell
from the shaver head.
1. Shaver head is cleaned with
water.
2. Cleaning cartridge is in use
for more than 8 weeks.
1. When cleaning the shaver head with water only
use hot water and from time to time some liquid
soap (without abrasive substances). Remove Foil
& Cutter cassette to let it dry.
2. Change cleaning cartridge at least every 8 weeks.
Battery performance
dropped significantly.
1. Shaver head is regularly
cleaned with water but not
lubricated.
2. Foil and cutter are worn
which requires more power
for each shave.
1. If the shaver is regularly cleaned with water, apply
a drop of light machine oil on top of the foil once
a week for lubrication.
2. Renew Foil & Cutter cassette.
Shaving performance
dropped significantly.
1. Shaving system is clogged.
2. Foil and cutter are worn.
1. Soak the Foil & Cutter cassette into hot water
with a drop of dish liquid. Afterwards rinse it
properly and tap it out. Once dry apply a drop of
light machine oil on the foil.
2. Renew Foil & Cutter cassette.
Cooling element is
warm.
1. Shaver was used with
cooling function a couple of
minutes before.
2. Battery capacity is too low
for the cooling function.
1. You can use the shaver like this or turn on the
cooling function and wait a few seconds until it is
activated again.
2. Charge the shaver after each shave to ensure
sufficient battery capacity for the cooling
function.
Shaver head is
damp.
1. Drying time after automatic
cleaning was not sufficient.
2. Drain of the Clean&Charge
station is clogged.
1. Clean directly after shaving to allow enough time
for drying.
2. Clean the drain with a wooden toothpick.
91004880_CoolTec_CEEMEA_S6-88.indd 9
21.07.16 12:25
CSS APPROVED Effective Date 22Jul2016 GMT - Printed 27Sep2016 Page 9 of 88