14
w
On/off switch
e
(–) setting button (sensitive)
r
(+) setting button (intensive)
t
Reset button
z
Shaver display
u
Shaver-to-station contacts
i
Shaver power socket
o
Travel case
p
Special cord set
Before shaving
Prior to fi rst use you must connect the shaver to
an electrical outlet using the special cord set
p
or alternatively proceed as below.
Installing the Clean&Renew station
• Using the special cord set
p
, connect the
station power socket
6
to an electrical outlet.
• Press the lift button
2
to open the housing.
• Hold the cleaning cartridge
7
down on a fl at,
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station
as far as it will go.
• Slowly close the housing by pushing it down
until it locks.
The cleaning fl uid display
1
will show how much
fl uid is in the cartridge:
up to 30 cleaning cycles available
up to 7 cleaning cycles remaining
new cartridge required
Charging and cleaning the shaver
Insert the shaver head down into the cleaning
station. (The contacts
u
on the back of the
shaver will align with the contacts
3
in the
cleaning station).
If required, the Clean&Renew station will auto-
matically charge the shaver. The hygiene status
of the shaver will also be analyzed and one of
the following cleaning program indicators
5
will
light up:
new
fast clean
fast clean
fast clean
2
1
trimmer
Series 7
99973404_795cc_S4-50.indd 14
99973404_795cc_S4-50.indd 14
06.07.11 15:01
06.07.11 15:01
