Page 3
For technical questions, please call 1-888-866-5797.
Item 64078
Charging Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
NOTE:
Before using Work Light for the
first time, fully charge the Battery.
1. Plug Adaptor into Charging Jack
on back of Work Light.
Charging
Jack
2. Plug Adaptor into a grounded 120VAC outlet.
3. The Charge Indicator on Adaptor will turn Red
during charging. When charging is done,
it will turn Green. Unplug the Adaptor.
NOTICE:
Do not leave the Battery in a discharged
state. Charge the Battery every 3 months if the
Work Light is not in use. This will keep the Battery
from wearing down and add to its life. Do not charge
the Work Light at temperatures below 40° F.
Operation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
NOTE:
Before using Work Light for the
first time, fully charge the Battery.
1. To adjust angle of Work Light, loosen
knobs on side of Work Light, make
adjustment, then tighten knobs.
2. Press Power Button on back for Low,
again for High and again to turn off.
3. When finished using the Work Light,
store indoors away from children.
Battery Removal
NOTE:
Contains Li-Ion battery. Battery must
be recycled or disposed of properly. Do not
open, crush, heat above 140° F or incinerate.
1. Unplug Adaptor from Work Light.
2. Remove four screws from back of
Work Light, then remove cover.
Screws
3. Remove two screws holding down Battery.
Screws
4. Disconnect Battery wires from circuit board.
5. Remove Battery.
