Brasilia OPUS SUBLIMA, Руководство пользователя

Страница: 22 / 28

Rev 0 - 09-2008 ENGLISH / 19
8 CLEANING
8.1 GENERAL CLEANING RULES
- DO NOT use water jets to clean the machine.
- DO NOT use detergents containing alcohol or ammonia or use abrasive sponges to clean the machine.
- USE specific detergents for cleaning coffee machines or dishes only.
- The chemical detergents used for cleaning the machine and/or the system must be used with care
to prevent the deterioration of the components and the environment (degradability > 90%).
- Clean the grinder-dispenser constantly and check on the state of wear of the grinders.
- Clean the Hyperwand steam wands accurately immediately after use, to prevent outbreaks of bacte-
ria or the formation of deposits than can clog the holes of the diffuser, and also to prevent other types
of previously heated drinks from altering the taste of the drinks being heated.
WARNING: Incorrect maintenance and cleaning, using non-softened water, may damage the internal
parts and lead to unexpected interruptions to the water flow and unexpected jets of liquid or steam,
with serious consequences!
8.2 DAILY CLEANING OPERATIONS
Clean the headsprays, the group seals and the filtre-holders with a coth/sponge.
Rinse the filters and filtre-holders in hot water adding specific detergent, to remove greasy coffee
deposits.
Attach and then detach the filtre-holder from the group, after having mounted the blind filtre, perfor -
ming a few deliveries.
Automatic cleaning of the groups:
• Prepare the group as follows:
1) Detach the filtre-holder from the group (det. A fig.1) and replace the brewing filtre (det. B fig.1) with
a blind filtre (det. C fig.1).
2) Put the recommended quantity of detergent in the blind filtre (det. D fig.1).
3) Reattach the filtre-holder to the group (det. E fig.2).
4) Cleaning phase starts by pressing STOP for 4 successive times for each touch key pad.
5) At this point the machine will start the coffee group cleaning phase, which will last for a total 3
minutes approximately.
The cleaning phase is divided as follows: 30-second operation, 5-secondi pause, all repeated 5 ti -
mes. The flashing green dose LEDs and the orange LED indicate the whole duration of the cleaning
phase (dets. 2-3-4-5-6 - see picture of the touch key pad).
6) You can interrupt the cleaning cycle by pressing STOP on the respective touch key pads.
7) One of the green dose LEDs will go off to indicate the end of each stage of the cleaning cycle. When all the
LEDs are off, the cycle has come to an end (Fig. A-B).
Fig. A
Fig. B