Brandt WFH 1481 D, Руководство по эксплуатации

Страница: 50 / 92

48
G
Installation
Transit bar removal
A
Before the washing machine is operat-
ed, the transit bars must be removed!
Otherwise the appliance may be dam-
aged in operation.
Required tool:
13 mm ring or box spanner.
1. Loosen all three screws A , until they
will turn freely.
2. Push the screws A sideways and pull
them out, complete with the distance
sleeve; remove the tie-bar
B (if exist-
ing).
3. Fit the three covers C (from the hard-
ware bag) to the openings in the rear
panel. Use a suitable tool (e.g. a
screwdriver) to push them in.
Store the transit bars in a safe place.
• They will be required if the washing
machine is to be transported again
(e.g. if you move house).
A
Never transport the appliance without
installed transit bars!
A
B
A A
A C
The proper location
Install the appliance in a stable, level posi-
tion in frost-free surroundings.
A
If there is danger of frost, drain all re-
maining water (see "Care and mainte-
nance").
A
The floor must have a sufficient load-
bearing capacity!
If, for example, you place the washing
machine and a dryer on top of one an-
other, this combination can – when
loaded – reach a total weight of
160 kg.
A
If mounted on a pedestal:
Install seats for the front feet to pre-
vent the appliance from falling off
when spinning. (Customer service cat-
alogue no. 0005323700)
Important:
• Do not stand appliance on the power
cable.
• Keep at least 1 cm distance to walls of
other furniture.
• Place the appliance only on a firm
floor, do not place on a long-pile car-
pet or similar.
Changing hinge position
If you wish to open the door to the other
side, you can have the hinge position re-
versed from left hand to right hand or vice
versa by our service technician.
Built-under installation
This appliance can be installed under a
worktop. A cover plate is required for built-
under installation (customer service cata-
logue no. ET 9.38.662.31).
A
Only authorised specialists are permit-
ted to carry out a built-under installa-
tion.
In addition, we recommend to fit two slid-
ing plates under the appliance's feet.
Levelling
Required tool:
17 mm open ended spanner, spirit level.