Brandt TI616, Руководство по установке и использованию

Страница: 26 / 76

2 2 // USING YOUR APPLIANCE
EN
26
USING THE MEMO BUTTON
This button allows you to programme the full
cooking cycle for a particular preparation.
Only one memory cycle can be carried out at
a given time on the hob.
• • To programme a cooking cycle:
1 1
Place your receptacle on the cooking zone.
2 2
3 3
4 4
Set the first power level
Each new power level setting is then saved as
well as how long it will run for.
5 5
Stopping and confirming the programme
• •
• • Using a programmed
cooking cycle:
1 1
Place your receptacle on the cooking zone.
2 2
3 3
A fixed dot appears and the saved power
levels scroll down.
The power level and timer display locks set
and the cooking begins.
• • NB
- When the cooking is finished, the display
shows a 0 and a beep sounds roughly every 5
seconds for a few moments. To cancel this
information, press any button from the
“MEMO” cooking zone.
- When using MEMO you can return to the
normal function (not MEMO) at any time by
pressing on the “-”, “+” “pre-selection” but-
tons to modify your setting or “stop” to stop
the cooking.
- To replace an existing saved programme,
use the procedure detailed in the paragraph:
“To programme a cooking cycle”.
short
press
long
press
up to....
The dot flashes while your are
programming
short
press
short
press
short
press
• • Operation:
- From 1 to 5 successive cooking phases can be saved in the same “MEMO” cooking cycle.
Beyond 5 phases, “no” displays, and the programming finishes.
- The duration of each phase must be at least 10 seconds for it to be entered into the pro-
gramme.
- The timer can only be used during the last phase of programmed cooking.
- The pre-heating function is not available in “MEMO” mode
- Using the “MEMO” function takes priority if you are using both cooking zones on the same side
of your hob. At high power, the cooking zone on the other side may have its power reduced. A
BEEP will alert you if this happens.
99640142_A_ML.qxp 17/04/2007 16:35 Page 26