Brandt DFH13114B, Инструкция по эксплуатации

Страница: 17 / 28

When the working cycle has finished, then stop.
Turn off the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
The program light is on but is not blinking, only in this case the programme has ended.
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
Forgot to Add a Dish?
At the End of the Wash Cycle
A forgotten dish can be added any time before the detergent cup opens.
Add forgotten dishes.
Close the door.
After the spray arms stop working, you can open the door
completely. 2
3
Open the door a little . 1
4
5 The dishwasher will run after 10 seconds.
12
Change the Program...
If you open the door , the machine will pause. The program light will
stop blinking unless you close the door . After you close the door ,the machine will keep on
working after 10 seconds.
during a wash cycle
NOTE:
When you press the Start/Pause button to pause during washing, the running indicator will
stop blinking and the dishwasher will mooing every minute unless you press the
Start/Pause button to start.
NOTE:
Premise:
1 A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
2
Press the Start/Pause Button to stop washing , then press programme button for more than 3 seconds , the programme will
cancel.
Then you can press the program button to select the desired cycle setting, p
ress the Start/Pause Button,
the dishwasher will run after 10 seconds.
(See the section entitled " Starting a wash cycle. . ." ).
WARNING!
It is dangerous to open the door when washing,
because the hot water may scald you.