Brandt BT650MA, Инструкция по эксплуатации

Страница: 4 / 16

4
1 -
EN
1 - INSTALLATION
1.4 - L
EVELLING THE MACHINE
(Diagram 1.4)
The appliance must be installed on a horizontal
floor. If required, and if it is equipped with adjusta-
ble feet at the front of the appliance, stabilise your
washing machine so that it is level. If it is fitted with
retractable castors, it may be moved by pulling the
lever underneath the appliance completely to the
left.
1.5 - E
LECTRICAL CONNECTION (Diagram 1.1.1)
Ensure that the indications on the data plate of the
Appliance are respected.
1.6 - C
LEANING BEFORE USE
Once installed, your washing machine must be clea-
ned by programming a cotton cycle at 90°C with
nothing inside and with half a dose of washing pow-
der.
1.2 - C
ONNECTION TO THE WATER SUPPLY
(Diagram 1.2 )
Connect the feed pipe with its new washers to the
coupling on the rear of the washing machine and to
a tap with a threaded Ø 20x27 endpiece.
1.3 - D
RAINING
(Diagram 1.3)
Position the drain hose, fitted with the curved part,
ensuring that the instructions shown on the dia-
gram are respected and especially that the connec-
tion is not air-tight: air must pass freely between the
drain hose and the drain to avoid used water from
flowing back up the hose into the machine and bad
smells being caused.
H
— Remove the 3 hose support clips, and place
E
1.1 - U
NPACKING
(Diagram 1.1.2 to 1.1.4)
The following instructions must be respected :
— Remove the chocks from the lid and flaps of the
drum and open and close the drum carefully.
— Lift the washing machine and remove the
motor
chock and base (Diagram 1.1.2) .
B
A
holes (Diagram 1.1.3) .
D
— Remove the strip and place the stoppers in the
C
the stoppers in the 3 holes (very important)
(Diagram 1.1.4).
F
2 - USE
R
ECOMMENDATIONS
:
— Before inserting the linen, sort it by colour, how
dirty it is and the type of textile. Empty all pockets,
close zips, removes hooks from curtains, place
Small items of underwear in a mesh bag.
— Remove any loose buttons, pins and clips.
— Knot belts, and ties for aprons, etc.
2.1 - L
OADING YOUR WASHING
(Diagram 2.1)
Operate the handle of the lid and open the drum
by pushing the button
.
Once the linen has been put in, ensure that
the drum has been closed properly. Ensure
that the edge of the button is visible.
A
2.2 - W
ASHING PRODUCTS AND ADDITIVES
(Diagram 2.2)
The product drawer has 3 compartments :
pre-wash (powder), wash (powder or liquid),
softener.
— Use detergents that are certified for domestic
washing machines.
— Do not use liquid detergents with the pre-wash
cycle and/or delayed start.
— Do not exceed the MAX level.