Présentation de votre lave-vaisselle
51
GB
Présentation de votre lave-vaisselle
50
GB
- Check that there is salt
in the reservoir (light
unlit = OK)
- Check the water hardness
at the tap and that the
water softener is set cor-
rectly. Set it on a higher
setting if necessary.
- Water too hard for using
a “3 in 1” detergent
recommended.
- Check that the salt pot’s
stopper is firmly closed.
- Check the water hard-
ness at the tap and that
the water softener is
set correctly. Some
detergent tablets are
more aggressive to
glasses and decorations
(change the detergent,
use a protective product
if necessary).
- Turn the open ends (of
glasses, bowls, etc.)
towards the jets
- Increase the amount of
detergent
- Select a more suitable
programme, with a
higher temperature.
- Check the indicator light
and fill the reservoir
completely, set the dis-
penser to the upper
position if necessary.
- Replace with a recent
agent (a good rinse aid
dilutes easily and foams
in cold water).
- Chalky film (can be
removed with vinegar).
- Traces of salt
(item ahs a salty taste)
- Opalisation of the glass
because water too soft
(cannot be removed).
- Items poorly arranged
- Not enough or poor
detergent
- Programme with too
low a temperature.
- Insufficient or no rinse
aid.
- Poor or out-of-date
rinse aid.
White marks
(Identify the nature of
the marks)
Coloured marks (tea,
wine, coffee, blood)
Run marks or dried
droplets on the glasses
Troubleshooting, what to do?
Poor washing results
Possible causes
What to do
- Remove the filters and
clean them and the drain
hole. Remove any large
amounts of residue from
the plates before placing
them in the dishwasher.
- A normal but infrequent
occurrence only when
drying starts (connec-
ted with the temperatu-
re of the room,
draughts, etc.).
- Arrange the items cor-
rectly; use the most sui-
table areas and acces-
sories for each type of
item (see Operating
Instructions).
- Check that the agitator
rotates freely (sizing
wire), set the basket to
the High position if nec-
essary.
- Check the seating and
the tightness of the fil-
ter (screw it in fully to
the right).
- Remove and clean all the
filters (with warm water),
including the sieve.
- Increase the amount of
detergent; try another
detergent.
- Select a programme
with a higher tempera-
ture.
A lot of residue left on
the main filter at the end
of the cycle.
Steam appears approx.
20 minutes before the
end of the cycle (model
with ventilated drying).
Traces of food, deposits,
“grains of sand” in the
glasses.
Greasy marks.
- The drain hole and the
filters are blocked by
too much residue.
- The steam from drying
is in contact with a flow
of cold air.
- The washing up has
been badly arranged
(items masked by
another, larger item or
placed under it, items
side by side or nesting
together).
- The upper agitator is
blocked by cutlery,
plates, etc.)
- The filter is not screwed
in tightly and is lifting
during washing
- The micro-filter’s sieve
is clogged.
- Too little detergent,
poor detergent, stale
detergent.
- Unsuitable programme
(temperature too low,
not long enough).
Troubleshooting, what to do?
Poor operation
Possible causes
What to do
Poor washing results
Possible causes
What to do