INSTALLATION INSTRUCTIONS
7637 Instructions 6-9-14.docx
Page 2 of 4
Step 4: Insert connector end of the Camera
Harness through the hole(s) you drilled.
RECOMMENDED: Protect Camera Harness from any
sharp metal edges by applying a small amount of
silicone caulk or a rubber grommet (shown below)
to any area that may come into contact with metal.
Step 5: Route Camera and/ or Chassis
Harness along existing wiring and secure
using Wire Ties or Electrical Tape.
IMPORTANT: Ensure harnesses move freely with
the trunk or liftgate.
Step 6:
Connect Camera Harness to supplied
Chassis Harness
. The optimal location for this
junction may occur at the top of the liftgate or
inner trunk edge.
Step 7:
Route Chassis Harness forward
. It
may be necessary to remove sill plates, pillar
covers, side panels, etc. Use a Plastic Trim Removal
Tool to avoid damage to trim pieces.
Step 8:
Use a Plastic Trim Removal Tool remove
lower driver knee bolster and upper dash visor
trim.
Step 9: Remove 3 Screws as shown and
remove dashboard cover. Locate IMD screen
and disconnect the 32pin harness.
Caution: Be
careful not to disconnect antenna or other
connection to back of radio.
