INSTALLATION INSTRUCTIONS
7631 Instructions 5-30-14.doc
Page 2 of 4
Step 1: Determine Camera location.
Place
template in desired position to confirm fitment.
(IMPORTANT: Some states prohibit items blocking
the license plate; check local authorities to confirm
legal status for your application).
Step 2: Mark Camera location with supplied
template, Center Punch the mark, and use
supplied 19mm Hole Saw to drill Camera
mounting hole.
NOTE:
If your vehicle has a
liftgate panel/ trunk trim cover, it must be
removed.
Step 3:
(
If necessary) Use a
¼
” Drill Bit to
make a pass through hole in any obstructing
panel for the Camera Harness connector.
Step 4: Insert connector end of the Camera
Harness through the hole(s) you drilled.
RECOMMENDED: Protect Camera Harness from any
sharp metal edges by applying a small amount of
silicone caulk or a rubber grommet (shown below)
to any area that may come into contact with metal.
Step 5: Route Camera and/ or Chassis
Harness along existing wiring and secure
using Wire Ties or Electrical Tape.
IMPORTANT: Ensure harnesses move freely with
the trunk or liftgate.
Step 6:
Connect Camera Harness to supplied
Chassis Harness
. The optimal location for this
junction may occur at the top of the liftgate or
inner trunk edge.
Step 7:
Route Chassis Harness forward
. It
may be necessary to remove sill plates, pillar
covers, side panels, etc. Use a Plastic Trim Removal
Tool to avoid damage to trim pieces.
Step 8: Use a Plastic Trim Removal Tool,
7mm Socket, and/or Phillips Screwdriver to
remove garnish and fasteners securing the
radio display.
Step 9:
Remove Radio, Unplug all radio
connectors from the radio head unit and set
radio aside.
NOTE: If vehicle is NOT equipped with a 22-
pin radio connector (Figure 1), use supplied
Gray connector to complete Steps 22 & 23.
Figure 1
