INSTALLATION INSTRUCTIONS
Step 7: Route Camera and/ or Chassis
Harness along existing wiring and secure
using Wire Ties or Electrical Tape.
Step 8:
Connect Camera Harness to supplied
Chassis Harness
.
Step 9:
Route Chassis Harness forward
. It
may be necessary to remove side panels, etc. Use
a Plastic Trim Removal Tool to avoid damage to
trim pieces.
Step 10: Connect Power Harness male RCA
connector to RCA located on your Display.
Step 11:
Using a vehicle specific service
guide/wiring diagram and a multi-meter
verify 12v Ignition or Reverse power source.
Red wire of power harness connects to 12v+
Ignition or Reverse power and Black wire of
power harness to Black chassis ground nut or
wire.
RECOMMENDED
:
Solder wires and cover with
Heat Shrink Tubing or use T-taps as an optional
connection method.
Step 12
:
Coil any excess
Chassis Harness and
secure it to existing vehicle wiring with Wire
Ties or Electrical Tape.
Step 13: Test system.
Clear all removed items
from around the vehicle before starting the vehicle.
Next, shift into Reverse and check display.
Step 14: (If necessary) Adjust camera aim
using the supplied fork tool.
Reposition camera
to the desired viewing angle.
Step 15: Reassemble vehicle
. Follow your
disassembly steps in reverse order, taking care not
to bind the harness wiring when reinstalling trim.
CAMERA OPTIONS
The camera offers park lines or non park
lines
Park lines options:
Default setting
displays
park lines are off
. To turn on park line
display, remove connector at end of camera
harness.
Connector to green wires on the Camera Harness.
