INSTALLATION INSTRUCTIONS
with Optional Park Lines
(Kit # FLTW-7610)
Please read thoroughly before starting installation and check that kit contents are
complete. This kit uses existing light from vehicle PN#68169776AB
Items Included in the Kit:
Tools & Supplies Needed:
Camera
Gasket
Chassis Harness
2 Bolts
2 Washers
2 Nuts
4 Screws
Camera adjustment tool
These Instructions
Phillips Screw Driver
Wire Ties
Electrical Tape or Heat Shrink Tubing
Plastic Trim Removal Tool
Soldering Iron & Solder
(Recommended)
Vehicle service manual (If needed)
Safety Precautions:
•
Work in well ventilated area that is clear of obstructions.
•
Secure vehicle with tire chucks in both front and rear of tires.
•
Turn vehicle accessories OFF and ensure ignition key is in OFF position.
•
Wear safety goggles and snug fitting clothes.
•
Use tools only for their intended purpose and which are in good repair.
•
Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation
instructions.
Step 1: Remove high center red light from
vehicle.
Unplug connector of lamp.
Step 2: Insert connector end of the Camera
Harness through the hole.
Step 3: Mount camera base to vehicle using
the provide nuts and bolts.
Step 4: Route rear lamp connector though
camera base and surround.
Step 5: Use screws to mount camera
surround to camera base.
Step 6: Connect and mount high center red
light to camera surround using provided
screws
