INSTALLATION INSTRUCTIONS
AVMS-3604.doc
Page 5 of 9
Section 4:
360º module installation
1.
Connect the correct camera plugs to the
360º module. Front, rear, left side, right
side, CVBS and CVBS RV.
2.
The CVRS output, is video output controlled
by the power on/off button to the system. It
is connected to the video input on the
mirror or AUX video on the interface.
3.
The CVRS RV output, is video output when
the accessory is powered on. It is
connected to the camera input on the
mirror or camera input on the interface.
4.
If not done so yet connect the power
harness to the 360º module. Wire up the
power connections, yellow is constant, red
is accessory, black is ground, blue is
reverse.
5.
Do not mount the 360º module, you will
need to get to it for calibration of the
cameras.
6.
Plug in the Key Box and mount to the right
side of the steering column on the das trim
with the tape provided.
7.
To turn on the system press the power
button on the Key Box. To change camera
views press the car image button. A long
press will show a full front view another
long press will show a full rear view.
8.
Place the vehicle into reverse to see the
rear camera image on the screen.
Section 5:
Installation of the 4” MyFord interface
1.
Remove dash trim around screen/display in
dash.
2.
Remove the (4) 7mm screws holding the
screen into the dash.
3.
Remove the screen from the dash.
4.
Check compatibility of screen/display on the
last page of this install guide.
5.
Remove the 6-pin connector from the
harness, if connected, then plug the
harness into the 6-pin connector on the
9002-2780 module included in this kit.
6.
Connect the 12-pin power output and
camera input harness to the 9002-2780
module.
7.
Disconnect the FCDIM/display harness on
the back of the display by pushing down
on the tab and pulling the “lever” back.
8.
Connect the T-harness into the FCDIM first
from the 9002-2780.
