9002-9516 Operating Instructions (Auto Dimming/Comp/Temp Video
Display Mirror)
Temporary Monitor Manual Shut Down:
If while in reverse you require to turn OFF the camera monitor simply press and release the POWER button on the mirror. (Note: once
reverse is disengaged the mirror will go back to normal operation and will turn ON next time reverse is engaged).
Temperature and Compass Set up, Calibration and Testing (if equipped)
Your mirror maybe equipped with a screen which displays the current temperature as well as the current orientation of the vehicle.
Once the mirror is installed it is necessary to calibrate and test the function of these features.
Temperature settings:
The temperature may require approximately 20 -30 minutes after installation in order to achieve proper temperature reading.
The mirror can display either Fahrenheit or Celsius. In order to select either mode simply press and hold the POWER button for 4
seconds until F or C appear, press POWER button to toggle between each mode and once correct reading is set wait 4 seconds and it
will be stored on the mirror.
Compass Calibration:
In some cases CAL will be displayed on the LED read out. If this not being displayed simply press and hold the POWER button for 12
seconds to initiate calibration mode.
1) Identify the appropriate zone from the chart below and then press and the POWER button until Z plus the current zone is displayed
on the LCD.
2) Press and release the power button to toggle through the available zones until the appropriate zone is displayed.
3) After the LED displays the selected zone wait 4 seconds and the zone will be stored into the mirror.
4) Locate an open area in which the vehicle can be driven at 5MPH or less in circles approximately 2-3 times.
Once the system calibrates the CAL message will disappear from the LED display.
