INSTALLATION INSTRUCTIONS
Step 29:
Plug the Power Harness RCA connector into provided
jumper harness.
Step 30: Insert the white 22-pin connector into the
back of radio.
Dealer Programming Instructions
PARK VIEW REAR BACK-UP CAMERA
VEHICLE CONFIGURATION
Vehicle VIN must be updated with the sales code of
the added accessory to enable system functionality.
Using the DealerCONNECT website and the scan tool,
complete the procedure below:
A. Log on to https://dealerconnect.chrysler.com
B. In the “Vehicle Option” screen under “Global
Claims System” category in the “Service” tab,
enter the VIN and add the following sales code:
XAC (PARK VIEW REAR BACK-UP CAMERA) as a
“Dealer Installed Option.”
C. Confirm that the new sales code has been
successfully added to the VIN. With the scan
tool connected to both the internet (via Ethernet
port or wireless connection) and the vehicle,
perform the following steps:
D. Using the scan tool, select VEHICLE
PREPARATION and then select RESTORE
VEHICLE CONFIGURATION.
Follow the step by step instructions on the scan tool
to complete the Park View Rear Back-Up Camera
vehicle configuration.
Step 31: Test the system. Start vehicle and shift into
Reverse to check that all connections were made
properly. If all the connections are correct, you will
see the camera image displayed on the factory
display screen.
To enable or disable the camera
input, select from among rear vision options in radio
settings.
Step 32: Reassemble vehicle. Follow your
disassembly steps in reverse order, taking care not to
bind the harness wiring when reinstalling trim.
NOTE: This camera can display parking grid
lines or no parking grid lines as well as
mirrored image or non-mirrored image options.
Parking grid line options: Default setting is to
display parking grid lines. Remove parking grid
line display by connecting the two green wires
near the end of the camera harness.
Display options:
(Not to be used in this
application!)
Default setting is mirror image
display for rearward facing camera (rear view)
installation. Change to non-mirrored image for
forward facing camera (front view) by connecting
the two white wires near the end of the camera
harness.
Green and white wires on the camera harness.
9002-8858 Instructions 6-10-19.docx
Page 7 of
7
KB
