INSTALLATION INSTRUCTIONS
5.
Remove passenger side sun visor using a T15 Torx
bit.
6.
Use a Phillips screwdriver to remove Phillips fastener
on upper-A pillar and remove pillar.
7.
Remove lower A-pillar cover (no tools required).
8.
Pull down right side of header panel.
9.
Run supplied Mirror Harness to Mirror location.
10. Splice the red and Black wires located near the
10-pin connector on supplied Mirror Harness to the
below indicated wires of the factory mirror harness
using solder and cover with heat shrink tubing
(recommended).
Splice the green wire located near the 10-pin
connector on supplied Mirror Harness to the below
indicated wires of the factory mirror harness using
solder and cover with heat shrink tubing
(recommended).
16 Pin Position 9 - Reverse White/Gray to Green Wire
16 Pin Position 13 - 12v Ignition Pink/Yellow to Red Wire
16 Pin Position 8 – Ground Black to Black Wire
9002-8846 Instructions 9-17-19
Page 7 of 8
DM
